MR-ZT15 Condensation Unit Teaching Equipment Heat Transfer Demonstrational Equipment
I. Product content 1. Product Overview 1.1 Overview The MR-ZT15 condensation process heat transfer test bench is a teaching device used by the laboratory to verify the difference in heat transfer between different condensation processes. Condenser tubes made of different materials can be used to test two different condensation heat transfer methods: film condensation and bead condensation , Bead-like condensation is formed on the polished gold-plated surface of the condenser, and film-like condensation is formed on the matte copper surface of the second condenser. During the experiment, the temperature of the loop can be controlled to change the boiling point and pressure during the experiment. The temperature, pressure and flow rate of the relevant points can be recorded through the sensor set in the loop, and the measured value can be directly displayed on the digital display or directly transmitted to the PC via USB. 1.2 Features ① MR-ZT15 Condensation Process Heat Transfer Test Bench The experiment process is carried out in a transparent experiment tank, and the process is clear and observable; ②The temperature of the test bench loop can be adjusted to change the boiling point and pressure during the experiment; ③The test bench is equipped with different condensation surfaces to distinguish between film-like condensation and bead-like condensation; ④The transient data during the change of the workbench is directly displayed on the display in digital form; ⑤The various physical quantity data of the workbench change process can also be transmitted to the PC through the USB interface for further processing; 2. Precautions The incoming power supply of the test bench should be correctly connected, and the grounding should be good and reliable. When using, keep your hands dry and clean, and be careful not to scratch the surface of the equipment with sharp objects. During the experiment, after the wiring is correctly connected, the instructor should confirm that the instructor is correct before energizing the experiment. It is strictly forbidden to touch the live parts with your hands or conductive objects, and you will be responsible for the electric shock. When working, the power-on experiment shall not exceed the rated voltage and power range of the device. After the experiment, check whether the switches of the console and the main power switch are completely turned off. Process water limit: 1000L/h
