MR018E Instrumentation Training Kit I. The introduction of the experimental device The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Let students practice troubleshooting. See Appendix 1 for the relative position of the fault repair switch. The fault switch of each template is factory-based, based on the principle that the circuit works normally. Place the switch in the normal position after troubleshooting. II. Technical parameters (1) Input power: two-phase three-wire system 220V±10% 60Hz (2) Weight: Around <50kg III. Training Kit including Installation, Commissioning and Testing Kits consisting of the following modules: Temperature Regulator with PID controller Thermal Sensors (Photoconductive cell, Phototransistor, Linear variable differential transformer- LVDT) Buffers and Inverters Comparator with switchable hysteresis Amplifiers with gain and offset control (Current amplifier， Summing amplifier, Differential amplifier, Instrumentation amplifiers ) Filter (Low-pass filter with switchable time constant) Integrator and Differentiator with switchable time-constant Voltage/Frequency and Voltage/Current converters Operating voltage: 230V (50 Hz) Warranty Period: Minimum One Year on equipment
